Hα occurs when hydrogen is ionized where intensity increases

with the H2 flow rate. The intensity of the CH spectral peak declined slightly as the H2 flow rate increased, revealing that increasing the H2 concentration improves the rate of decomposition of the mixture MEK162 in vivo gas. The C2 dimers in plasma during the plasma-assisted thermal CVD are critical to the formation of various carbon materials [26]. Furthermore, the acetylene-like C = C bond produces a carbine structure, possibly yielding a two-dimensional carbon material, graphene, with the evolution of nuclei. Figure 3 Typical plasma emission spectra of H 2 and CH 4 gaseous mixture. With various H2 flow rates from 5 to 20 sccm. Total gas pressure is 0.5 Torr and applied DC pulsed power is 200 W. Figure 4 indicates the Raman spectra of the graphene films that were synthesized on Cu foil at various H2 flow rates from 5 to 20 sccm at a low temperature of 600°C. Typical features of the monolayer graphene are observed. They include (1) a 0.5-G-to-2D intensity ratio and (2) a symmetric 2D band that is centered at approximately 2,680 cm−1 with a full width at half maximum (FWHM) of approximately 33 cm−1. The 2D band is related to find more the inter-valley double resonant Raman scattering, and the peak of the G band is produced by the E 2g phonon at the center of the Brillouin zone around approximately 1,580 cm−1. The D band is associated with the breathing modes of

the sp2 atoms and is activated by a defect. Sharp single Lorentzian 2D band was observed at approximately 2,700 cm−1 when the H2 flow rate exceeded 10 sccm. The intensity of the D band decreased with increasing H2 flow rate indicating not only increased Tariquidar clinical trial crystallization of Arachidonate 15-lipoxygenase graphene but also in CVD graphene on copper, the formation of C-H bonds as out-of-plane defects. Overall, hydrogen plays an important role in the growth of graphene

and in determining its quality. This result is consistent with Figure 3 and previous investigations [27, 28]. Figure 4 Raman spectra of graphene films that were transferred from copper foil to the SiO 2 /Si substrate. Samples were synthesized at 600°C by plasma-assisted thermal CVD using various H2 flow rates from 5 to 20 sccm for 5 min. Figure 5 plots the intensity ratios of the 2D and D peaks to the G peak. As the H2 flow rate increases, I d/I g declines from 0.33 to 0.13 and I 2d/I g increases from 0.98 to 2.29. The lower 2D band and higher D band reveal that the more disordered graphene growth, the lower is the H2 flow rate. Interestingly, the 2D-peak FWHMs (39 to 35 cm−1) of the series of samples varied slightly with the H2 flow rate because the low solubility of carbon in copper makes graphene growth self-limiting, and a higher H2 concentration improves the inter-valley double resonance in the Raman spectrum. Figure 5 2D-peak FWHM and intensity ratios of 2D and D peaks to the G peak. As functions of H2 flow rate.