Clearly, there is a linear relationship (curve fit

shown) between the surface energy and the relative surface area, reaffirming that the observed surface energy is physically confined to the surface of the particles and that the relative amounts of surface energy increase for decreasing LY3039478 price particle sizes. Figure 9 Normalized surface energy vs ratio of surface area to volume ( S ratio   = 6/ D ). The data plotted in Figures  6b and 8 are replotted with respect to the relative surface energy in Figures  10 and 11, respectively. From Figure  10, it is clear that the nominal compressive stress increases as the surface energy increases (and as the particle size decreases), particularly Thiazovivin price at higher compressive strains. Figure  11 suggests that the apparent modulus measured from compressive unloading increases with increasing surface energies and decreasing particle sizes. Both Figures  10 and 11 RG7112 in vivo emphasize that decreasing particle sizes result in increases in relative surface energy, which result in increases in particle stiffness. Furthermore, because of the linear relationship between relative surface energy and surface areas shown

in Figure  9, it also implies that the compressive nominal stress and unloading modulus will show a similar dependence as a function of surface area. Figure 10 Compressive nominal stress vs normalized surface energy for three compressive strain levels. Figure 11 Unloading modulus vs normalized surface energy. Contact radius during compressive loading The simplest theory for estimating the contact radius during compressive loading is through the Hertz contact theory, which is most suited for linear-elastic materials under compressive strains under 1% [7]. This theory stipulates that the contact radius is calculated by [24] (9) For perfectly plastic materials, an alternative approach to determine the contact radius is [24] (10) These two approaches are most valid for two extremes in material

behavior: linear elasticity and perfect plasticity. However, polymer materials typically exhibit non-linear behavior that is between these two extremes, particularly the PE material Fossariinae considered herein [6]. Therefore, it is important to determine the accuracy of these two simple approaches when applied to polymeric materials. In Equation (6), the contact radius was determined directly from inspection of the molecular models as a function of applied compressive strain, similar to an approach used previously [26]. Figure  12 shows this calculated contact radius as a function of nominal strain, and particle size. As expected, the contact radius increases for increasing compressive loads and particle sizes. Also shown in Figure  12 is the contact radii calculated using Equations (9) and (10). These contact radii show the same general trends as the contact radii calculated from MD as a function of nominal strain and particle size.