One is located near the northern corner of the model domain (Fig

One is located near the northern corner of the model domain (Fig. 9a), where only limited well control exists (Fig. 2). Here, the low reliability of the Aramac Coal Measures seismic surface is demonstrated by discrepancies of the well log data and the seismic surface. This seismic surface only partially covers Tofacitinib datasheet this area, and where it can be found, it partially intersects the Basement seismic

surface (Fig. 9b). The Aramac Coal Measures is considered to be less reliable than the Basement surface, which, however, is also constrained by only two wells in this area (Cairnhope 1 and Wairoa 1, approximately 98 km apart). In addition, palynological assessment of the sedimentary sequences in these wells failed to identify the Aramac Coal Measures, suggesting that it is absent (Nugent et al., 1989). The low reliability of layers in this area relates only to the Galilee Basin, as the seismic surfaces of the Eromanga Basin

appear to be of better quality (the Cadna-owie and Toolebuc seismic surfaces match the formation tops in both wells). The second area of low confidence is located in the eastern part of the model domain (Fig. 9c), where seismic surfaces of the entire sequence are of questionable quality. For example, the position of the top of the Galilee Basin is uncertain here because the Aramac Coal Measures and Betts Creek Beds seismic surfaces have a steep dip, and almost reach the ground surface (Fig. 9d). However, there are find more no indications from surface geological mapping that these formations crop out in this area. In addition, stratigraphic logs of four wells in the area (Carolina 1, Carmichael 1, Fleetwood 1 and Lake Galilee 1) also confirm that the tops of the Aramac Phospholipase D1 Coal Measures and Betts Creek Beds are likely to be much deeper than inferred from the seismic surface. In this area, the data quality issues are also evident within the Eromanga Basin, where

the seismic surfaces indicate that the lower sequence crops out in this area, whereas the surface geology indicates the occurrence of Cenozoic and Quaternary sediments at the surface in these locations. These younger unconsolidated sediments are not included in the geological model due to their overall relatively small thickness in comparison to the total basin sequence; however, they also mask the actual position where Eromanga Basin formations are close to surface. Understanding the hydraulic relationships between coal-bearing units, aquifers and aquitards, and assessing if geological structures induce connectivity as barriers or conduits to groundwater flow, is an important component of the hydrogeological characterisation of sedimentary basins subjected to coal seam gas/coal bed methane exploration.

Leave a Reply

Your email address will not be published. Required fields are marked *

*

You may use these HTML tags and attributes: <a href="" title=""> <abbr title=""> <acronym title=""> <b> <blockquote cite=""> <cite> <code> <del datetime=""> <em> <i> <q cite=""> <strike> <strong>